04 grand prix

Done 2 so far and said I wouldnt do another...priced one today for 245.00 last 2 were 185.00 {dealer work} and customer made appt Got back tray and BG down pact but if I can figure out how to get the flipping door panels off I think the roll downs will be easier for a newby Tired of fighting seal with duck tape when its raining ///PS The bolts in the door handle on the last one just turned forever but wouldnt release ...both freaking doors Thanks

If memory serves
They require a THIN-Walled 1/4" drive socket on extension.
Otherwise the plastic "well" they sit deep down in will make your socket drag like your on the nut but your just skimming the tip of the hex bolt.

I know , I know, nobody pulls panels

I hate pulling panels ...especially with every tool in the 44 tools cataloge at hand but I just can deal with all the felt and rubber these darn windows were designed with one less obstacle might make me less stressed

Yep....What a dumbass design that is...I was looking all over for a socket to fit, but a deep-well, off a 1/4 in drive works.

2 out of three sockets will not work on that engineering marvel.

I've never had a gasket I couldn't do with the carpet sheilds!!G- Wiz,red devil,
edge works on some!!You mean that didn't work also!! Usually the sheild and the smallest of the G-Wiz parts seems to work perfect for me!! I did one 04 GP w/it!! It went fine,I see the car 6 days a week also!! Maybe it's just
my luck!!

Maybe I'm talking about some thing else (my bad)!!Let me check If it's
the same ride we're talking about tomorrow!! I'm getting old and
a car is a car to me now!!

What's everyone's problem with this car? I would install on those all day long and never complain It's a one beer car if you ask me.

Nobody said it was hard...just a dumbass design on the door panels if you choose to take em off.

Maybe I need a "speaker wizard" to get them panels off and speakers in. J/K

I love my carpet tape but the 2 I did it was raining and couldnt get the tape to stick enough mainly because the gasket was tight as hellllll..took a dealer car today and pulled the top of the door back and pulled the gasket out just to practice...screw the screws Thanks for everyones help..sure wish I had started tinting 20 years ago or even 10...I have as of 2 weeks ago been told I have arthritis is both arms and pulling door panels is like benching 300 pounds

I just did the same car this week , ez car and the bolts are 10 mm, I tried to pry the top but seemed to tight and don't want damage .

I don't get what the big deal is with this topic on this car.

Only a door plug puller required to remove plastic door handle cover, gasket and side rubber trim for easy install..similar to the old saturns