STS

tight but didn't remove.....

how in the world did you do that without removing?

I don't take the deck out either on those.

Me too..I slide the film down to about 2 inches from the bottom..Flushed the bottom to remove any debris then wiggled the sucka down..Used the red devil to gently lay the film
in place not pushing the water out, but just to set it. So when I go over it hard with side swiper there's no creasing..Since it's tight back there I don't power squeegee the bottom right away till the film's in position..15 so far all done the same way with Matrix laying down smooth..They would've never look so nice if this site never existed thanks y'all!!