05 deville

is there a secret to working with the low clearance and the bottom edge window of the back deck because it is a pain in the ass to clean well and fit tools down.

do you have to remove it? or can some1 tell me some good info thanks

never had a problem with em, just use a sideswiper, or a conquer and squeege it out

allright just checkin, i guess its just my lack of expierience and the fingers that appear when i tranfer the film from the outside to inside and i dont know where they come from cause i shrink it totally on the outside but it gives me a hard time on the inside.

You need to wet check the film on the outside after dry shrinking and after shrinking everything flat you need to force a few extra fingers to pop up and shrink them so it will be tight when installing.

all rigth thanks

dude you have to put the same tension on the inside as the outside. If you have it laying flat on the outside then it pops on the inside you probably missed something or you are pulling the tension different!....

i soap shrink dang near everything and dont have any finger problems...practice makes perfect..