07 ford escape

anyone know how to get em off drivin me nuts feel like im gonna break it

I just prop it up of the glass with an old squeegee or something

pull the plug out of the wiper-loosen the nut-should pull right off....

order a tool, will come in handy. ask your local windshield guy to buy one off of him. get the universal one with 2 prongs and two screwdowns.

just be careful on the ones that the post has an intergrated squirter. you can mess those up. the gti/rabbits have them and a couple others. just check before you clamp and screw.

pop the plug out, I think it's a 12 or 13 mm nut, and off it comes.

Thats what i said!

Glad you could help

Im still wondering why take it off...it needs minimum heat if any in that area.

He might be talking about the inside motor and stuff

yeah-he may be-I never took that off-but it is a pain in the !

if I remember right its a little like the vibe

If it is in fact the inside motor, it comes off with a reverse thread torx I believe. There might be a few more bolts in there. I just remember the reverse messen me up. The only reason I ever removed it because the inside cover was aginst the glass.

the escape is the same as a tribute, right

if so, I did a tribute last sunday and the rear wiper didnt have a nut holding it on, instead it had a tap that extends from the right side of the post, but to the top of the wiper arm, and it has a small hole in the top of the tab, just pull out on the wiper arm, and with a small seal pick or screw driver, pry up on the tab, then lower the wiper arm back down, and the arm will come right off