IS250

Last week at the lexus dealer I was having to show a new guy how to lay the doors on the new IS models. Stepped back and realized that I for got how I was dealing with that tweeter. Finally Rolled the window down and rolled the seal back half way and stuck the bone pusher behind the tweeter and used a bottom feed method. Removing the whole door panel just seemed to intense for the time alloted.

How do you guys lay em?

The new LX 570 is also the same .Lexus love the installer for sure

http://www.tintdude.com/forum/index.php?showtopic=38998

this is a general question so I dont think it requires some sort of special forum. You could of added more to the thread but just sharing your method IMO











--------------------------------------------------
my tone: Not being a smart ass at this time.

pull the panels

pull the door few screws

only two.... One right behind the inside door handle ( the black cover pops right off )....and then pop off the window switch panel on the inside of the door ( this pops off with a lil-chizzler and snaps right back on ) and one screw right there cant miss it. then pop the panel off from the lower outside corner. Done.

This whole process takes about 45 seconds......