90 trans am?

just wondering what people do around the defroster lines along the side of the glass on these. they're stupid, stick out like 1/4 of an inch from the glass and about 1-2 inches from the side. just curious what people do to cut around them

Pinstripe Em ! next post!

the best soultion is this.

have a look at the defroster lines on the backglass, if they are jacked up (which 90% of them are) ask the customer if they mind if you just pull the damn thing (braided wire) off because it will look 100% better that way, you can actually pull it off and scrape it clean. if the defrosters are fvcked the whole thing is fvcked anyways, might as well just get rid of it

if that dont work i just cut my film long on the sides and trim it on the inside, at this point its going to look like AZZ no matter what you do.

thats just me though

and if the wires d owork...pinstripe Em!

i was thinkin about cuttin inside the braided wire sh!t and painting to the edge, will this look like sh!t?

quicker and easier to run 2 lines of 1/2 " black pinstripe on the inside of the window..looks good, holds up ..same idea as using black vinyl over matrix..it'll only take 2 min.

I go back and splice in a small piece on each side.

Ditto