Compustar programing

Custom Search

TintDude Forum > Related Trades > Related Trades > 12 Volt Forum : Car security / Convenience

mywifesbox

Nov 26 2008, 09:28 AM

I recently installed a CM4200 on a 2008 Scion xB. I need to change the alarm to give a double pulse to unlock the doors. I can't seem to get into programing mode. It may be going in but how do I know it is and what is the procedure after getting in? The directions I have are kinda vague and confusing. Any suggestions?
Thanks in advance,
Eric

filmslayer

Nov 26 2008, 09:44 AM

It's been awhile since I've done 12v. but does'nt your supplier have a tech support # ....

mywifesbox

Nov 26 2008, 09:49 AM

They wont support you if you didn't purchase from a dealer or have the dealer install it. I did this install for a friend who purchased it somewhere else other than the dealer. I had never done a Compustar and doubt I will ever do another. haha

filmslayer

Nov 26 2008, 09:52 AM

Wish I could help ,but like I said it's been awhile and I've never worked with them either ....

mywifesbox

Nov 26 2008, 09:53 AM

Thanks for the reply though.

PaulD

Nov 26 2008, 05:55 PM

try this one

http://nustart.ca/support/NUA-Install.pdf

I-tinted-the-pyramids

Nov 26 2008, 11:49 PM

haha! like the name. TOOO FUNNY! I know its different to code every alarm. Had to double pulse one today.

For now we see through a glass, darkly; but then face to face:
now I know in part; but then shall I know even as also I am known.

© 1999 - 2009 Ric Wellman All Rights Reserved.
Contact: tintdude[a]gmail.com