About computerstar 1way programming

here the story i just when back from the dealer who sell me that alarm its a 1way computsar jr1600 one red boutton for lockking the door and start the alaram if hold and 3 other btn onr for trunk, remote starting and unlocking door

i got a electrical lock system on my subaru. last night i had to remove my car battery to repair something, since that time my alarm could not set back
i when to see them he did turn on and off my ingnition and push the locking boutton but he did it very fast and i sure he turn of my remote starter he want me to see hiom next week but i am sure he will say the mechanic guy broke it or something and i am mostly sure he turn it off

just wanna know how to turn it on again my modele is one of these CompuStar 1WAMR-G2 | RF-1WG2-AM
anyone can help me sort this out thx in advance


yaz109@hotmail.com

hi guy i just check the manual on compustar and i have check the troubleshooting for auto start

when i hit the auto start remote key my light in dash flash after a few seconde almost 30 sec later my parking light flash 3 time and another flash after 1 second pause between the 3 and 4 flash

assuming this is for the trunk if i refere to the manual

that possible since all my cable are broke and i have to put my trunk in lock mode to keep it close im repairing my wire for my trunk and fuel door this friday.
but my trunk is close.

maybe the hatch or something is stay in open mode that why i have to put inside the trunk in lock mode to keep it close so until i fix my cable ill wait and see

but if anyone of you know how to reprogram the remote start let me know what i do after the five time on and off i see the twice flash parking light after that do i have to go in tab menu two and push the remote start boutton?
have a look on this link that may help you

sorry im mostly french canadian

hope you guy can help

http://www.compustar.com/csupport/user_man...2_manualE_F.pdf