59 chevy elcamino

Any body have any luck on a rear glass if so what type of method to shrink it thanks

Mdog soap method works for me

one pieace are two pieace

One piece. It's tough but can be done with care. Take it slow and easy. Shrink it on the outside first before you you install it. It tries to pop up when you install at the extreme curves. I just heat the glass and use a squeegie wrapped with a paper towel and work it. Now, I do get the glass and window rubber extremely clean before I even start. Sometimes I try to have the classics for at least a couple of days before hand so I can clean the window rubbers and glass really good. This gives the time needed for all that extra water to dry so I have less trouble with the water and dirt wicking up under the film.

Thanks you just mention how to solve one problem i appericated it

Hmmmmmmmmmmm.....trying to figure this posting pics thing......

nice job what type of film you use

Great job

I use Madico. I put 20% Charcoal on this one. I know. . . .not legal.

Was wondering how it went on that back glass you were trying to do? Just curious.

i have one for wed.lol.simple window,i'll post pic's.
shrink on outside,lays in pretty easy,imo

i had some luck shrinking it but laying the film was not want to stick on the curve

now that's a sweet job and ride Tint Lady!!!!!!!!!!!!

Another thing you can try to get those curves to lay is to mix a little rubbing alcohol with your soap and water mix and spray those areas before you lay the tint. The alcohol helps it to dry faster and you can get ito stick. I forgot to mention that.

Ya talking about my Z71 Tahoe or the El Camino? LOL! Just kidding. thanks! I get to work on a lot of old hot rods. Week before last I Did a sweet 74 Plymouth Gold Duster. It was a piece of Cake!!!