Sign in to follow this  
Followers 0
kylebialo

1999 chrysler lhs fingers on the top of window

2 posts in this topic

I am tinting my first car, and I am noticing after I cut the tint to size, round out the corners, and start to lay it down, there are fingers on both the bottom of the window and the top. This wouldn't be an issue, but I am afraid to cause the top tint to shrivel since it is not attached to the glass. Is there any way to cause all the fingers to go to the bottom? I successfully got my back two windows done, but I had to take it extra slow to avoid shriveling the tint at the top.

Share this post


Link to post
Share on other sites

Use your hard card to just move them to the bottom before you shrink. I'm assuming you're shrinking before install? Or you could also shrink top fingers out before you trim top edge. Avoiding "shriveling"

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0