Jump to content
egetorp

Cleaning windows after install

Recommended Posts

This is probably a dumb question but how do you clean windows after install?  I use sprayaway cleaner and microfiber cloth.  But all I seem to accomplish is smearing them and they look smudged and dirty.  

Share this post


Link to post
Share on other sites

Use less SprayAway and make sure your microfiber is only used for SprayAway and doesn't get used on a door panel.  

Armor All will get on it and it will start smear after that. :cleanwindows    Too much SprayAway will dry wrong. :twocents

 

Edited by Bham

Share this post


Link to post
Share on other sites

I use a glass microfiber towel to clean them.  For roll downs I don't usually even use sprayway just the moisture left from my final squeegee pass.   I mist the back window lightly for a final clean but I also don't clean it until the last thing.   If I did the final clean on it right after tinting I would just use the moisture. 

Share this post


Link to post
Share on other sites

I try to use the microfiber cloth but was getting the same results. I started to wrap my hard card in a Scott's towel (blue paper towel) on my final pass and it cleaned the window up very well. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×