Jump to content
Advertise on TintDude! Contact us for details.
Contact us at admin@tintdude.com
spacer
Advertise on TintDude! Contact us for details.
Contact us at admin@tintdude.com
spacer
Tint Techs

Visor strip cutting

Recommended Posts

On 5/24/2018 at 8:37 PM, Tint Techs said:

What are the new tools out there for cutting visor strips? Without plotter.

The 10" roll helps, i was saving strips from extra back window material, what a pia.

Share this post


Link to post

I agree, a 10” roll makes life easy. When I reorder 5% I order the 30” roll and have them cut it 20/10 so I have a roll for side windows and a roll for visors. One edge will be better than the other so just check before laying out your film on the WS and put the cleaner edge on the bottom.

I usually just grab a tape measure and pull measurements from the top molding to the bottom of the visor and make sure it’s the same on both sides.

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×