Jump to content

shrinking around hardware


Guest val

Recommended Posts

using a toyota matrix as an example, do you guys remove the buttons to shrink around the area or not? they are positioned at a curve that seems to need srinking but it seems impossible to get it smoothed out in that area with the hardware in place. after three attepts, I still had some problems smoothing out the circles, am I trying to get it too perfect befor the install or am I missing something altogether? thanks for any help on this

Link to comment
Share on other sites

Guest Sprinter
Remove buttons, dry laminate a small scrap of film to the glass exterior covering each hole, lay film for shrinking, and shrink. :rock

[*]218023

never heard that before, but I could see it working just fine! :thumb

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...