Jump to content

Fargin heat gun!!!!

Guest ninjatinter

By Guest ninjatinter
in Window Tinting - General Discussion

Recommended Posts

Guest ninjatinter

Guest ninjatinter

Posted
Posted

So I am tinting a nice Vette the other day, and I am giving the bottom of the doors one last finger check. I walk from pass side to driver, and extension cord gets caught on the tire. I give it a good tug...... nothing. I give it a huge tug, cord comes unglued, sending heat gun smashing into the window!!!!!! DOH!!!!! I got lucky cuz it didn't scratch the glass, but man it put a huge "seatbelt" ding in that film. :woowoo told him it would cure out. just kiddin I had to redu it of course.

Link to comment
Share on other sites
Guest Key West

Guest Key West

Posted
Posted
So I am tinting a nice Vette the other day, and I am giving the bottom of the doors one last finger check. I walk from pass side to driver, and extension cord gets caught on the tire. I give it a good tug...... nothing. I give it a huge tug, cord comes unglued, sending heat gun smashing into the window!!!!!! DOH!!!!! I got lucky cuz it didn't scratch the glass, but man it put a huge "seatbelt" ding in that film. :dunno  told him it would cure out. just kiddin I had to redu it of course.

[*]276158

REALLY gotta suck to be you!!!!(just kidding) I hate it when that happens! I once spent about 30 minutes shrinking the rear window of a 240 sx (I think) and as I was giving the bottom one last swipe of the squegee, I tore the film with my watch :woowoo Never wore jewelry again while working :lol

Link to comment
Share on other sites
Guest tint rookie

Guest tint rookie

Posted
Posted

my personal favorite heat gun story... same intro. the ol last once around checking for fingers. had a card between the teeth, blade in one hand, gun in the other. so ya needed a free hand for the card in my mouth to smash out a finger. what should you do?

a) put the blade in my pouch or pocket. grab card with that free hand?

b) put the gun down. grab card with that free hand?

c) put the hot gun under your arm, suffer a 2nd deree burn in your armpit and send the customer off in a car with a slight hint of burnt armpit hair, because you USED to look like you had buckwheat in a headlock.

in a hurry, I went with C. amazing how you dont think when you are in a hurry.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Go to topic listing
  •   Sponsored by
    tintwiz

    signwarehouse

    martinmetalwork.com

    autocut-tech

    tinttek

    filmvinyldesigns

    ride wrap

    Lexen

  • Activity Stream

    1. 0

      WINDOW FILM INSTALLERS/PPF/WRAPS FOR HIRE

      GREAT PAY , FLEXIBLE HRS, BONUS PAY IF YOU CAN INSTALL PPF/WRAP. COME JOIN A LEADING COMPANY IN THE INDUSTRY SINCE 1993. 2 LOCATIONS PASADENA AND GLENDORA CALIFORNIA. ALSO FLAT GLASS OPPORTUNITIES WITH OUR SISTER COMPANY. WE PROVIDE COMPANY VAN FOR FLAT GLASS PROJECTS CHECK US OUT. VIPCENTERS.COM MODERNTOUCHFILMS.COM REACH OUT TO ROBERT 626 255 4987 VIA TEXT OR EMAIL 1ROBVIP@GMAIL.COM.
      ROBVIP in Classifieds • Employment • Marketplace
    2. 0

      Sub contractors needed East Tx 27k security film and caulking

      I’m looking for sub contractors for a project I have in east Texas. The scope is roughly 27,000 sq ft of security film with structural silicone taped and tooled. You must be able to pass a background check and fingerprinting to work on this site. Please call or text 775-420-7975. Thanks.
      Kata87 in Classifieds • Employment • Marketplace
    3. 0

      Austin, TX - Experienced Window Tinters - Full Time- $1000 Signing Bonus - W2 - Year Round Work - Willing to Relocate

      Company Background: Auto Tinting Austin LLC is a 5-Star rated Window Tinting business established in 2013. We offer high quality products, expert installation and excellent customer service. We Offer: -A Very Positive and Supportive Work Atmosphere -Consistent Work Year Round -Very Competitive Pay -Air Conditioned Bay -Tool Allotment -Snacks and Lunches -$1000 Sign On Bonus -Willing to Assist in Relocating the Right Candidate -Porter and Tint Shop Support Team -Plotter, Bottles, Shampoo Etc All Provided Job Duties: Seeking experienced window tinting technician to install automotive window film. Experience with plotter and hand cutting. Ability to operate manual vehicles for parking and moving. Will work with a helper team that can step in to cut film, move cars, remove film. Positive atmosphere. Hours: Schedule is open Monday-Saturday. Pay: $1000 Sign on Bonus! $1000-$2500+/Week Full Time, $300-600/Day Part Time ---BASE PAY AND TIPS!! Please call to schedule interview. 512-956-8468 Manager: Jody/Aric Auto Tinting Austin LLC 1601 Bench Mark Dr. Ste C Austin, TX 78728 www.AutoTintingAustin.com Job Type: Full-time Job Type: Part-time Pay: $1500-$2500+/Week Full Time, $300-600/Day Part Time
      AutoTintingAustinLLC in Classifieds • Employment • Marketplace
    4. 0

      Total OffRoad & More is now hiring for our Nationwide Stores.

      Total OffRoad & More Is seeking experienced window tint installers or will train the willing and energetic right candidates for the following locations. Raleigh North Carolina, Charlotte North Carolina, Charleston South Carolina, Greenville South Carolina, Norcross Georgia, Kennesaw Georgia, Virginia Beach Virginia, Pelham Alabama, three locations in Houston Texas, Pittsburgh Pennsylvania, Naperville Illinois, South Elgin Illinois, Columbus Ohio, Cincinnati Ohio, Ogden Utah, Phoenix Arizona, Gilbert Arizona, Tucson Arizona, El Paso Texas, Albuquerque New Mexico, Indianapolis Indiana, Cleveland Ohio, Baton Rouge Louisiana, Memphis Tennessee, Nashville Tennessee, Tacoma Washington, Seattle Washington, Portland Oregon, Tigard Oregon, Salt Lake Utah. Contact for more information Brenttint@totaloffroad.com 5618915160
      Brenttint in Classifieds • Employment • Marketplace
    5. 1

      TINT SOFTWARE

      Film & Vinyl Designs 100%
      InkblitzMedia in Window Tinting - General Discussion
    6. 9

      Low angle haze

      I've never been asked for any kind of cert. Of course I probably sound like your average salty installer that's had enough of everyone's crap.
      Dano in Window Tinting - General Discussion
    7. 9

      Low angle haze

      I've been ordering here, filmnow.com. Shipping to CO is pretty quick. I usually call to get a 60" cut down to 38/22 rather than just ordering online.
      Dano in Window Tinting - General Discussion
    8. 9

      Low angle haze

      I reached out to global, info@global email. Do they have any sales requirements, or certification requirements? We'll see how long it takes for them to reply. Or does someone have a local rep near Denver?
      Ricardo Perez in Window Tinting - General Discussion
    9. 1

      Best place to learn window tint ppf

      Ppf is going to be the easiest for you to transition to coming from detail and being familiar with car body shapes. Tinting can be alot more challenging to get right in a detail shop, even for an experienced installer. Taking the class from Xpel would probably benefit you in your position because it would (1) give you brand support for ongoing install questions. (2)becoming a dealer would probably be easier after having gone through their training and beginning a professional relationship. (3) likely give you access to a protected product area. Ask first to make sure that access will granted. (4) you would most likely be added to their list of installers on their website if you are accepted as a dealer. For someone just starting out the dealer/marketing support would be helpful, even if you pay a few dollars extra as compared to taking a random class and whinging it. Once you've been at it for a few years any solid brand/product will do, however, some prefer the dealer model for the obvious benefits and build their buisness around it. You'll find what works for you after you've been at it for a few years. Good luck and post any install questions you might have once you get started. This is a really good/helpful community here.
      Dano in Window Tinting - General Discussion
    10. 9

      Low angle haze

      I've got the ceramic 70 in a heat/light cube with the ceramic 30, HP30 and clear glass. That stuff is amazing, especially when you can see it side by side. I suspect it's two layers of ceramic base films laminated together to meter at 70vlt. I hope they never change it. Thanks @Bham. Believe it or not I really enjoy educating the customers to find out what they really need and not try to oversell just to turn a buck. Most of my new clients come from older referrals and when they find me I keep em for years. For sure more people are catching on to the product name and I've yet to have a piece of HP or the ceramic fail that wasn't my own fault. It's nice to know I'm not paying for a bunch of marketing collateral and a butt kissing salesman to travel around pass out tshirts and coffee cups that's added into the cost of my roll stock.
      Dano in Window Tinting - General Discussion
×
×
  • Create New...