Jump to content

Rapid Tac 2 Quetion


uncle bob

Recommended Posts

Have just installed 6 etched glass panels 610 x 2400, reverse cut and fitted on the inside of the windows. These were a variety of text and parallel lines 50mm wide. Anyways, read all this great stuff about RT2, but felt I was not any better off than my usual johnsons baby bath and water that I use for film application.

Cleaned glass, removed backing paper from vinyl, sprayed glass with RT2 (not a lot) applied vinyl, squeegeed twice, moved onto next glass, same again, etc,etc. When finished on last glass went back to first expecting to remove app tape, no way. Had to go back next day, and even then a couple of small pieces of text were still awkward.

Any advice, tips would be greatly appreciated as I have another 4 of these to do

Sorry for babbling on :dunno

Uncle Bob

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  •   Sponsored by
    signwarehouse

    tinttek

    filmvinyldesigns

    ride wrap

    tintwiz

  • Activity Stream

    1. 10,296

      The Off Topic Thread

    2. 12

      Tint shop owner please reply

    3. 0

      Would you please suggest an IR/Solar REFLECTIVE tint for my Mitsubishi Outlander panoramic roof?

    4. 7

      How to shrink film on windshield?

    5. 12

      Tint shop owner please reply

    6. 12

      Tint shop owner please reply

    7. 12

      Tint shop owner please reply

×
×
  • Create New...