Curve b/g (Renault Symbol)

[graphik]

Window like this...

Problem zones

First window what I can't do... :\

Can u help me?

[Guest fimmo]

anchor the tint along the centre but only the centre section! not right to the edge.

start at the sides but heat from the side of the car looking upwards or downwards rather than standing at the back of the car aiming straight at the tint.

sounds silly but that how I get round these kind of windows, we dont see that car in the uk (clio saloon) but I have seen one recently and it doesnt look that hard. the clio has a stronger curved rear glass but its similar, especially down the sides of that rear window.

oh and it helps to oversize the tint your putting on,for example dont cut it round the edge first, put the tint over the window,make sure its more than overlapping every edge, and cut it after shrinking.. I used to cut the tint on the black border,then shrink,then final cut around the edge nice and tight but realised it was easier to shrink out the fingers if the tint was larger and overlapped the window.

good luck!

[LEO'n'DARTZ]

Window like this...

Problem zones

First window what I can't do... :\

Can u help me?

Eto pizdec

[graphik]

Leo, ti nad mashinoy rzhesh, ili nad moim voprosom? )))

Nu bla, nu ne poluchaetsa u mena eto ebanoe steklo... nichego ne mogu podelat'

[vanja]

what film do you use?

[matty cox]

I would dry shrink the bottom with talc powder, and use a lift and pull heat shrink (wet) on the top, that will lay that screen down nicely.

[fphillips]

Leo, ti nad mashinoy rzhesh, ili nad moim voprosom? )))

Nu bla, nu ne poluchaetsa u mena eto ebanoe steklo... nichego ne mogu podelat'