laser level idea

[JJAWS]

Would using a laser level work on a car/truck when doing a front drop/ strip. To get it straight? I been using a tape measure and marking the glass to get it level.

[coast2coasttinting]

I use my knife and blade as a way to get each side the same height. Unless someone want a really low strip. Then I use a tape measure.

[Ryker]

laser level would take more time than just measuring it up. If you are hand cutting a contour then it is pretty easy to get it evenly done. I use a sharpie and my hand to mark them....

[TintWizard]

I've eyballed them for 20 + yrs and havn't had a complainer yet

[flat rock stan]

laser level would take more time than just measuring it up. If you are hand cutting a contour then it is pretty easy to get it evenly done. I use a sharpie and my hand to mark them....

I've eyballed them for 20 + yrs and havn't had a complainer yet

X2

[kats2112]

Get the laser level. You can keep it on the shelf, next to the film stretcher.

[lostinbama]

Get the laser level. You can keep it on the shelf, next to the film stretcher.

[coast2coasttinting]

the film strecher is a life saver. Great when you cut a piece short. the

[JJAWS]

Get the laser level. You can keep it on the shelf, next to the film stretcher.

lol

[TintWizard]

Isn't that film stretcher made by the same company that has self paint blotting dye so you don't need a paint pen for those missed areas around defrost tabs ?