2008 2 door cobalt back window

[tintcartel]

any tips on the back glass on shrinking?

[Booms]

Yeah...take your time...it's doable, but patience is a virtue....

 

Your welcome....

[Ryker]

taught a kid to shrink film on one of those.  Not that hard just have to know how to handle the film.  Lift and pull the top corners.

[alberts316]

Lots of lift and pull.  

[Lock]

Just did one yesterday so it's still fresh in my mind. Not sure your skill level but I'll explain how I did it. I use the dry shrink method. Lay your film out leaving extra film on top and bottom. I anchored the film slightly below the halfway point leaving slightly less to shrink on the bottom than top. Then I do a combination of lift and pull/ stretching while hard carding.

Take it slow but don't be intimidated. Honestly it looks more difficult than it really is.

Good luck

[tintcartel]

thanks guy will deff take my time on it , it just looked a bit curvy since my neighbor has one but im not doing his

[coast2coasttinting]

I don't lift and pull them. I shrink them just like every other backglass, but I do them slower then the average car. Once you have done a couple they aren't to bad just big.

[Tintmaster08]

Shrinking it is half the battle, putting it in is a different story. Those headrest can get in the way.

[coast2coasttinting]

Only a fool would try to install that backglass with the headrests in place.

[TintWizard]

Only a fool would try to install that backglass with the headrests in place.