3m Prestige 70 on Display case

[Epic.Tint]

Did this one by myself. Front glass was 91x68 and since there was no room anywhere to set up the California roll I back-rolled it sideways out of the box worked beautifully.

[Ocala]

That had to be fun to do! 

[baloochow82]

were they trying to keep the chocolates from melting? good job

[Tintguy1980]

were they trying to keep the chocolates from melting? good job

Sure going to be tap dance another pitch when they do.

 

Air80 from LLumar didn't stop the chocolate from melting and the client was thoroughly peeved. It cost a fellow tinter a chain store project in europe.

[vquestfilms.com]

Pulled it off once with Huper Optik Drei but had to do the storefront glass instead of on the display case. They had to sacrifice some VLT to keep the chocolates from melting but in the end it made a drastic improvement.

 

This install looks nice but think about TSA on just about any film not to mention a high VLT with any kind of TSER (>40%). Absorbed and convected energy is going to get trapped in that case because there is no ventilation. I hope it works out but I don't know?

[Tintguy1980]

You know I just had to pull the stick pin out on this one.  

 

Agreed something as effective as Drei should go on the storefront glass.

[Epic.Tint]

They were trying to stop it from melting. There was only glass on front and sides. Back was wide open. They actually had 70% exterior film on side of building but not in front so that's why they opted to just get the front and one side by register done. I called them after a couple weeks and they said the cupcakes stopped melting.