Storage solutions

[WearTheFoxHat]

9 hours ago, coast2coasttinting said:

Round 50 gallon containers. And what I don't use I throw out about once a week. 

[Angelo]

starting out i did the same, multiple sizes. i found im most efficient with this setup. 12" rolls of 5% for strips. all hand cut. then 24" rolls for doors, and 36" rolls for backglasses. this will do everything i need. the middle and right rollers of my plotter are for 24", then flip tension of middle roller up and the two outsides do the 36". this way i never have to move the rollers. keeping up inventory with 20" and 24" was a headache. this saves time and money imo or maybe im ocd lol. as far as scraps, they get chunked. theres a method to everyones madness.

[flat rock stan]

On 2/20/2017 at 11:50 PM, Master. said:

never  use scraps. all rolls 60 and templates from the liner allow to cut off almost without waste

@Master.  In my travels teaching in your part of the world most shops use 60 inch rolls exclusively.  Much less wast than here in the states

[Master.]

On 17.03.2017 at 1:01 AM, flat rock stan said:

@Мастер.  Во время моих поездок , преподающих в вашей части мира большинство магазинов используют 60 - дюймовые ролики исключительно. Гораздо меньше еси , чем здесь , в Штатах

in what year you were in Russia?

[Guest]

Can't even keep track of my coffee cup, sure don't have time to look for scraps...cheers

[Tintpuppet]

Charge enough to where you don't have to worry about scraps....lol

[Angelo]