Heat shrink help please

[John B]

My heat shrinking bites ass. I can’t get the tint to lay flat for the life of me. If I start at the bottom my fingers climb up I can’t seem to push everything down. I constantly crease or burn more crease tho. I suck and I keep trying and I’m not getting any better. Any help out there for me?

[DynamicATL]

Check out this video on dry shrinking, this is roughly our method.

 

 

[Ryker]

Is the film the right direction? Need to shrink towards the factory edge...

[no ma'am]

55 minutes ago, Ryker said:

Is the film the right direction? Need to shrink towards the factory edge...

This was my first thought 

[John B]

Ok I’ll make sure. Thank you. 

[John B]

1 hour ago, DynamicATL said:

Check out this video on dry shrinking, this is roughly our method.

 

 

 

[John B]

Ok thank you. Appreciate it. 

[no ma'am]

13 minutes ago, John B said:

Ok thank you. Appreciate it. 

Next time you screw up take a picture and let us see? Video and film type will help us help you.

[John B]

Ok will do. 

[1 Touch Tint]

I’ve had windows with overspray or something similar on them before. This will cause the film to actually “float” too much and not allow it to lay down after you shrink and card it down. Typically you will start to over shrink the film and possibly start to burn it. If this is the case I will usually blade the outside of the window to avoid this.