Jump to content
spacer
spacer
Sign in to follow this  
Fivestarcardetaling

New plotter user need help.

Recommended Posts

Hello Everyone,
I am a new plotter user. I purchased the GCC Jaguar V. I have used it  5 to 6 times so far but now when I use it I get a lot of shifting taking place when I am printing to the point where the PPF crumples up. I have the speed of the plotter at 6. Are there any tips on how to stop this from happing in the future.

Thank you.

Share this post


Link to post

Best tip is to get a Graphtec.  I had a Jaguar 72 inch for a while.  The problem is the rollers that hold the film were too flimsy and would bow out with the weight of the roll of film.  Since the roll had to be orientated to the right, the rollers bowed in the middle and that caused the film to feed crooked.  It would only cut 60 decent since that one sat more in the middle and the bow was less.  

 

I'd try cutting off just a little more than you need and just feeding that cut part though the machine.  That way you aren't resting the weight of the entire roll on the rollers.

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...