Is 35.25” x 23.75” workspace too small for peel board?

[peaktint 0]

I found a glass table I could use for a peel board but the workspace is 35.25” x 23.75” so just a little short for the rear windshield. Would it be ok? I am a total beginner and learning for the first time. Would it be an issue if a little bit was hanging off the table? If I had to cut on the corner would I have to take the tint off the glass each time to adjust it and get the corner on the table to cut it?
 

thanks 

Edited February 28, 2020 by peaktint

[CnCCustoms 148]

We use a 4’x6’ glass peel board. But we also now use a plotter I cut all 4 doors and quarters on one sheet. So that size you mentioned wouldn’t cut it. As far as a back glass. Most are gonna be 30” tall or more and same wide. Kinda small either way

Edited March 6, 2020 by CnCCustoms
Added text