Ridler

This car is cake. Frameless and super easy back window just like every other BMW. Rear brake light pulls out like every other one. There is a fuse panel on right side of trunk but easy to get to so you can cover it up. All in all not a bad car to tint.

So here's the report on this new $100K performance luxury car. Back seat and window is tight to get into. Watch the bottom corners of the back window. The C pillars are tight at the bottom. Side and quarter windows needed shrinking. While the main doors looked like both top and bottom needed shrinking, I just did the bottom and didn't have any issues. The back of the side glass has a 3/4" blacked out area so you can be a little forgiving on your cut along back edge. I used FVD patterns and they were pretty good. Front doors also drop down when you open the door so I just remove the screw holding the sensor in the jamb completely and they stay up no problem.  Here is the final product.




 

Here is some pics of the rear deck and the lid turned upside down so you can see where the clips are. Just not that the clips tend to stay in the decklid and need to be pried out and then put back in the deck lid. Also note the C pillars need to be taken out as well in order to get the deck lid out.