TranslucentTP

Back again two years later. Which material do you figure is best for application? I've used TPU and PET. TPU ended up an easier install, it contoured to the surface easily and was able to wrap around the table to provide protection on the sides. PET was the hard material which I would've favored more. It's theoretically an easy install if it was just a flat table, however with existing sink/stove setup it proves difficult to cut around. As well, does brand matter in your opinion? I used Alibaba TPU and let it sit for a year, the edges did not want to stick even with tac solution. Do you think material thickness also plays a role in contour over the edges?

Did you end up going through with this? I'm looking into getting into the same industry but I did fall into one problem. Usual car ppf is made out of a softer material so when I installed it on my table it made the table feel more like ppf than table if you know what I mean. It's also grippier so it held onto my glassware, tableware, etc when I moved it across the table. I tried looking at StoneGuard and they use a different material that's glossier and slicker? Do you know what this material might be?