Jump to content

2013 chevy cruze


JJAWS

Recommended Posts

im not a panel puller but save your self the headache and pull them. 2 torx screws, pop panel and lift up and off, tape felt.... other wise its a pretty straight forward car.. back glass is easy.

Link to comment
Share on other sites

Guest MidcoastMW

I just did one of these today, and you are correct... super tight bottom gasket. I left the panels on and taped the side felts. Came out pretty damn clean. If you leave the panels on I would without a doubt shrink each door window. The first one I didnt... fought a finger until the rest of the car was complete. :blowtorch

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  •   Sponsored by
    auto-precut.com

    signwarehouse

    martinmetalwork.com

    tinttek

    filmvinyldesigns

    ride wrap

    Conco

    Lexen

    tintwiz

  • Activity Stream

    1. 4

      At What VLT% does visibility start being impacted

    2. 0

      WE ARE HIRING - Window Tinter needed Waldorf MD 20602

    3. 6

      Automotive Tint Comparison

    4. 4

      At What VLT% does visibility start being impacted

    5. 0

      HIRING WINDOW TINTERS PPF WRAP TECHS

    6. 4

      At What VLT% does visibility start being impacted

    7. 4

      At What VLT% does visibility start being impacted

    8. 6

      Automotive Tint Comparison

    9. 4

      At What VLT% does visibility start being impacted

    10. 6

      Automotive Tint Comparison

×
×
  • Create New...