PaintProtectionPro

Have any of you had to change or had any issues with the Change Johnson and Johnson’s has made with there baby shampoo? It’s more clear And now a wash and shampoo. 

Well between my camera being on portrait mode blurring the edges and bad paint it makes it look way worse than it was. I didn’t even realize that in the post but I see it looking back. I went back through all the failures I turned in and they were all Pro 3. Here’s hoping I don’t see any pro 4 failures in 6 months! I’ve been told it’s all been fixed. Also the orlange peel is nothing like that. Here is a link to a full clip I did on a black Porsche.

I’ll make some calls Monday. I did a short demo of the xpel patterns and the ones I used were great. Guess it’s time to branch out!

Also those are not cut lines on the car. It’s just the glue edge. Im ready to branch out and try some other films. Any recommendations? I see all these install on YouTube where these people are flush cutting edges and one squeegee stroke and there down. It all seems like a fairy tail.

If I did my cuts and edges like this it would fail on every edge that wasn’t wrapped around 1/4 inch. 1 squirt and bam locked in. It just seems fake. 

Here is 1 example. Only 1 side failed and it’s about 7 months old. I redid the whole bumper and added a relief cut into this corner so I KNOW it won’t happen again. I have not had to replace 1 job in the last 4 years and now it seems like 1 in 5 cars I’m having some kind of failure.

So I have been installing paint protection film full time since around 2002 and have never really had any issues. Lately I have been having problems with long-term durability where I install a kit and then 6 to 7 months later there is a random inside corner section under a light or around a vent that has popped up and let go where the film has actually delaminated itself from the glue. Granted I get paid to warranty the product but I hate having issues like this and I hate having my customers have issues to deal with. I asked my rep and he assures me I'm the only one having this issue however I have a hard time believing this. I use the 3M pro series film. Installs stay at my shop at least 3 hours after install for QC and then are checked with a follow up about 2 weeks out. I just seem to have a slew of random failures popping up after about 6 - 8 months and I'm really over it!