Bean3M

Obsidian 3M, I’ve also used ceramic it. Plotter mainly, I use a handle squeegee with an Orange Crush bit. I start from the top where a 3rd brake light would be and go straight down as low as my hand will allow and then go right from the middle of the glass and take it all down from there. I do the same on the left side of the split I made and then user a slammer tool to secure the bottom and that’s where the fingers will some times come back. For the bottom I use the slammer starting from the middle and work my way to the side In both directions.

I full them off but only slightly. Behind the door handle on the inside there’s a black plastic you can pry off using a small common head screwdriver. Then there’s a 10mm you take off and now you can pull back the top of the toward you and with your hand or a hook tool you can take out the bottom felt gasket.

New here, does anyone one else have a bit of trouble with the back glass window ? I’ll first use a dryer sheet or soup the glass down and place the film on and do the H figure tack down and do it in quarters. After that I wet shrink to get the fingers I didn’t see out and yet still I get pesky fingers on the bottom corners from time to time when I install the film.