The ///Man Posted November 10, 2010 Report Share Posted November 10, 2010 Dry and stretch it, too much fighting wet. I just stick it in the middle and work it out from there stretching along the way. when I'm almost to the ends I trim down most of the excess and heat and hard card the lest little bit, like 1/4". Now I will say this might not work with precuts, but off a roll this is the easiest. Link to comment Share on other sites More sharing options...
blackout66 Posted November 10, 2010 Report Share Posted November 10, 2010 Try the mactac felt squeegee it works great! Link to comment Share on other sites More sharing options...
watchdaride Posted November 11, 2010 Report Share Posted November 11, 2010 i have been using a steamer to get the curves down. Is doing it dry is better? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.