-
Posts
2,267 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Subscriptions
Posts posted by quality tintz
-
-
3 hours ago, no ma'am said:
, I also like what @quality tintz said about a less soapy bottle for the bottom. I use dirt off that way. Just a little though it'll grab too quick if I try to set the whole bottom with it.
So you just spray towards the bottom edge with the dirt off??
-
1 hour ago, Jkatfelix said:
The equate stuff is good....I recently found Johnson's baby shampoo at the 99 cents store works amazing...and the shop has a filtered water system
Dollar tree?? Name brand baby shampoo or generic post a pic bro??? Thanks for reply
-
9 hours ago, IPATinting said:
I just tinted a couple windows this morning and on one window, the bottom would not want to lay down, after hearing it up, it finally layed down. So on the other window, I didn't use as much soap in the solution which helped a lot more but I still had a couple little fingers, both sets of fingers were right below the bottom seal. My question is will these small vertical fingers go away after a few days?
What are you using for solution???
-
Maybe try a less soapy bottle for bottom half are you using tint slime or dishsoaps dishsoaps makes alot of suds and messes stuff up on sticking if you have way too much soap try slime orange one or baby shampoo get your mix perfect just enough slip so it will dry watch shady and Ralph van pent they soak it up or push it out side ways and gasket wizards are killer they keep seals dry...
-
46 minutes ago, Jkatfelix said:
I rinse out my tank after each use....scrub once a week I use baby shampoo so I do get build up
Name brand or Wal-Mart equate brand??? Distilled water bro?? How you keep it clean with no filter???
-
Tint is dark at night mine is too...roll down the Window dummy haha common sense!!
-
1 hour ago, Tint Slayer said:
I did a search on "mobile garage" and saw a few nice tents for around 100 or less. I was thinking of the mobile thing at one time, bunch of ideas popped in my head, like i only need enough tent for the window i'm working on so maybe a small setup or 2, i also had a trailer i could fit a car on and pondered building onto the trailer a camper like thing that pops out on the sides so i can bring my garage with me. I also looked around for public covered garages in key areas that i could use. Like if they didn't have a garage i could tell them to meet me at a cool covered parking garage. I have a few friends with car shops, some will let me use an empty bay for $20 a tint job. I now have a physical shop and even in the enclosed shop i have dust issues. All i can say is work fast af lol.
On amazon i found a $300 generator that is good for 3500watts (4000 peak) (Champion, i also use it to power my house during outages). If it's just your heat gun you could get away with a 2000 watt, or you can use a torch for shrinking. just shooting out ideas. Let me know if you can make it work, i have a spare pickup i'd like to make the Tintmobile.
Any pictures of that mobile garage????
-
1 hour ago, Jkatfelix said:
Torch shrink BG and an ez up with one side tarped with weights at the bottom
What you use for weights
-
What helped on dusty vehicles is clean all the channels after taping felt...clean inside frame and everything and mist door panel and all around inside door...squeegee then install...
-
Need that but with some sides
-
2 hours ago, Stewy said:
Spray the floor a lil bit. Always keep your hands wet. Don't touch anything but the film. Don't let any wind get anywhere near you. Spray the air right before your remove liner. Install the film faster after you remove the liner.
Where is the contamination on your film?
Mostly on top edge it's getting better stew extra scrubbing with alchohol
-
20 minutes ago, smookee408@yahoo.com said:
😂 put the 🍺 Down. I think you might of had one to many. It's good thinking outside of the box though. Try controlling your environment instead. Like reducing clutter or area where dust can collect. Having clean floors and using a leaf blower will greatly reduce contamination. If you're really worried about lint then try wearing a nylon type jacket or pull-over.
Thanks suit and gloves helps 100 percent with cars why not tint???
-
Guys been thinking lately about stuff getting in tint..would gloves and a pantsuit work or armor wear??shady??plastic gloves for skin shedding??
-
-
-
41 minutes ago, shadytints said:
I like blues, stevie ray to set the pace and mood. (12 bar). known times I screw up. the after lunch food coma, always hard to get your groove back. year ago a cruz screwed up three times on BG, was over a hundred in shop, didnt know i was disoriented from dehydration. took a break, water and power aid, cut, shrunk and hung under 10min. lets not forget the polyTcar. (polyester to car) curse. oh, that one will be easy. almost done cakewalk car. say any phrases like that and plan on working overtime pulling hair
Wow you know what's funny before I did this door glass 3 times I hadn't messed up one window In like 2 months ....i had too much slip in bottle when I would put tint on window and tack down it was still moving now I'm cutting patterns out with light soap bottle problem solved back on track thank God!!!
-
Ouch those dam redos!!
-
46 minutes ago, wade_660 said:
I did a rear side window on a new Accord six times last week. No idea why, once I got mad it just went down hill. Kept creasing on install
Wow what year some days things just go wrong huh!
-
Thanks nice
-
4 hours ago, Tint Slayer said:
Just read on a website that 000 synthetic not recommended on glass. I'm going to try the 0000
Nice
-
7 hours ago, redneckj said:
I never have to clean my bottles. I use baby WASH or tint slime. The bottles stay clean.
You think the baby wash would do good in a 5 gallon tank???
-
10 hours ago, Jkatfelix said:
Yea it's not as strong if it's a bad crack or something snapped off use a Black glue stick
Wow my friend just told me this week about black glue sticks ...he said they work great!!!!
-
1 hour ago, driftmaster said:
Never ever unless I happen to gee some dirty water. Then just flush with clean water. I use the cheap pump up sprayers from Home Depot. Always test them in the store before you buy them. I usually get 2 to 4 months out of a bottle before it's wore out or dropped and broken.
???
-
1 hour ago, driftmaster said:
Never ever unless I happen to gee some dirty water. Then just flush with clean water. I use the cheap pump up sprayers from Home Depot. Always test them in the store before you buy them. I usually get 2 to 4 months out of a bottle before it's wore out or dropped and broken.
Any pictures of those bottles??
Does anyone know where i can get this part?
in Window Tinting - General Discussion
Posted
Nice thanks g