Jump to content

Audi A6 - some pointers please


Guest naughtydog

Recommended Posts

Guest naughtydog

Has anybodt tinted an A6 or RS6 yet??

I have taken lots of door panels off Audi's B4 when I worked at a dealership but not for 10 years or so...I bet they have changed some?? :booga

It's for my father in-law so dont wanna make a balls of it!!

Thanks

Naughtydog

Link to comment
Share on other sites

Guest naughtydog

I have'nt done many saloon vehicles in general. Do you ever take the side panels down to apply the film or do you cut it very tight on the matrix so you can get a hard card or other tool in there??

ND

Link to comment
Share on other sites

Guest Smoked

Word of caution.... if you heat any of the fingers that may appear at the bottom with the door panel on, be very careful.... the A6 interior panels are not very heat resistant..... melted one pretty good in one spot the other week !!!

Link to comment
Share on other sites

Guest BCCwintint
Word of caution.... if you heat any of the fingers that may appear at the bottom with the door panel on, be very careful.... the A6 interior panels are not very heat resistant.....  melted one pretty good in one spot the other week !!!

Thanks for that little tid-bit. Gotta tint an A6 next week. :thumb

Link to comment
Share on other sites

I do a lot of Audi's, I just did a RS6 today, that is a MEAN Car!!

The door pannels come off very easy, 2 screwes thats it, top right and top left, after you take out the 2 screws, just pull straight up on the door pannel there are hooks that hold it on, after you remove the pannel, just let it hang, its ok. then procede to remove the styraphome on the sides, then just pull the gasket out, very easy. Just make sure you remember how the styraphome goes back, its kinda tricky. Also when putting the pannel back on, put the lock in first, and line up the hooks and slide the whole pannel straight down, making sure the hooks and the lock are lined up.

I dont take off the pannels on the 4's or the 8's, just the 6's.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  •   Sponsored by
    filmvinyldesigns

    ride wrap

    Conco

    Lexen

    tintwiz

    auto-precut.com

    signwarehouse

    martinmetalwork.com

    tinttek

  • Activity Stream

    1. 5

      Automotive Tint Comparison

    2. 0

      At What VLT% does visibility start being impacted

    3. 5

      Automotive Tint Comparison

    4. 5

      Cracked glass

    5. 5

      Automotive Tint Comparison

    6. 0

      Better shop in Europe to buy Films and Tools?

    7. 0

      Paint Protection Film (PPF) is it needed or worth it?

    8. 5

      Cracked glass

    9. 5

      Cracked glass

    10. 5

      Cracked glass

×
×
  • Create New...