Wagner Wallpaper Steamer

[TTS]

Questions for those that use the Wagner wallpaper steamer from HD....

1) does it REALLY take 20 minutes to start to work as stated on the box ???

2) Which attachment do you use at the end of the hose for steam'n off film ? Do you use one of the 'bricks' it comes with ??

Thanks...

[Guest 1PEECBARETTA]

1 yes

2 none, just end of ho's

[TTS]

Man of few words.....

Thanx for the reply! ....... I don't know if I am patient enough to wait 20 minutes for the warm-up... (I was hope'n in reality it was quicker)

[Guest WASHBOY]

I have two steamer, forget witch ones but they heat up quick! Twenty mins is way too long, mine is ready in 2-5min depending on the weather!

[Guest willie]

mine is ready in 2-5min depending on the weather!

Mine can be ready a whole lot quicker, it depends on the chick

[Guest Crackz]

I use a cheap conair from wall mart it heats up in about 5 to 10 mins topps and once shes going it pumps out some steam man

[TTS]

I'll check out the conair.... Thanks!

[Guest Tintmart]

hmmm 20-25min I dont think so, then again I always put hot water in it so heats up alot quicker

[Guest cartek]

I have never steamed tint off of a car, do you just steam over the current tint and then peel? does it work that well, I am going to be upset if it works well and I waited til this long.

but I am still curious as to whether you just steam right over the $hitty purple tint and pull it off, or is it still a pain in the neck?

thanks

[Guest djtekk707]

So far I have untinted 2 cars with steam and have come off very clean. I use an old shark steamer bought at a garage sale for $5 and work like magic. The main thing is to take your time on dot matrix or else you will have glue which might be hard to take off on back glass.