Report
-
Sponsored by
-
Activity Stream
-
1
help arquitectural in Puerto Rico heat
Go with SolarGard TruVue 05. It's gonn be the best for what you're describing. Huge heat rejection, low heat absorbing to window. -
0
Flat Glass Installer NEEDED
Full time Flat Glass installer needed in Lady Lake FL. 3M film, residential and commercial. Mostly solar but some security. This shop has been under the same ownership and in the same location for 34 years. We are the oldest 3M dealer in the tri-county area. Chris Gehman Owner Underglass Auto Tech Inc 334 S. Highway 27/441 Lady Lake, FL 32159 352-753-5267 352-753-8886 fax chrisunderglass@comcast.net -
0
Now hiring experienced window tinter
Car Tunes Brandon is hiring to its growing team for full time position window tinter 8-6 Tues thru Saturday. Call Shannan or Jason with Car Tunes 813-661-4052 112 N. Parsons Ave Brandon,Fl 33510 -
0
Any XPEL Dealers?
Are there any XPEL dealers lurking that can answer a question? You can DM me if you prefer. -
13
Where can I order Window film online?
You can try Alibaba,and get some samples first.As I know,1 roll is about $100. Whats app:+86 18028875794; email: glassfilm@kashibang.com -
1
TintX Puremax and Koolmax
I’ve tried both pure max carbon and koolmax ceramic. So from what I’ve experienced the pure max is honestly very easy to work with and just feels right as the beginner I am. I’ve easily shrunken rear and front windshields as a beginner with the pure max so I know someonewith experience can easily work with it. However I’m not sure if just me but the koolmax ceramic has just been a headache thing to shrink on rear windows only. Heard the adhesive isn’t as good either especially by dot matrix’s which I encountered on a 2000 mustang. But yea I recommend the pure max line although I switched over to geoshield . -
-
4,171
-
4,171
-
7
Cracked glass
The above post is a bit controversial and naive in nature. May I suggest improving technical knowledge by using a film-to-glass chart, IWFA's study on window film use on dual pane glazing systems, and glass itself. Air/gas used in dual and triple pane glazing systems has zero impact on what gets installed. Absorption rate of film and glass edge quality impact the aforementioned glazing systems most. The film used in the OP has absolutely no reason to be installed to the exterior surface. Neither do the vast majority of film products that carry an absorption rate less than 50%. Start searching for good quality information to better serve you and your clients. And finally, installing on the exterior maybe has a life expectancy of 5-7 years before seeing degradation. Properly installing a product deigned for the interior (on the inside) increases life expectancy up 20-25 years, depending on the quality of the film.
-