Decorative Film Help - Die Cut Frost?

[Tint World E Ft]

Hey everyone,

 

A client has all of the bathroom windows done with a decorative frost film. They replaced one door and need to apply the same pattern to match all the others.  Its 1"x1" squares with 1/8" gap - Each square is individually cut out so you can actually feed the edges of each one. I found this pattern as a whole  but i'm trying to find the easiest way to get this done without having to sit there and space these squares out.

 

Anyone familiar with an easy way to go about this?

 

I can design and cut the pattern on my plotter - ween the spaces then possibly use a low adhesive transfer film to apply?

 

I was also thinking to cut on plotter, apply as a whole and then peel the spaces off the glass after installation.

 

 

Any other ideas would be greatly appreciated. 

 

 

 

Thanks!

 

 

Danny

[MikeMN]

Plotter cut and weed, med or low pre-mask, after install wet the pre-mask and let it sit for a few min and it will release more easily. 

[Slick]

Plotter cut and weed, med or low pre-mask, after install wet the pre-mask and let it sit for a few min and it will release more easily. 

[Tint World E Ft]

Thanks for the confirmation!  Was really hoping there was another way but I guess not.

[Slick]

One way that may be easier is to use frosted vinyl....