Help with a curved window install

[Johnnytint]

Doing a job as a sub (never seen the site)

I get there and 1 on the windows is curved big time

the windows is 118" H X 36" W and curved 90 degrees

Can I get LuLu frost film w/ PS adhesive to bend like this?

And its Plexi not glass

[Guest metint]

Sure... as long as the curve is in one direction.

[Guest vclimber]

..

[Johnnytint]

Hey MeTint

I put a piece of scrap on there and got some small fingers but they pushed out with a small amount of effort, however, this piece is almost 10 feet in length so If I get some small fingers can hit 'em with a heat gun (like auto film). It has a PS adhesive

Thanks

[VIP tint + glass]

if its llumar frost you shouldnt have to heat it. that adhesive is super strong and tacks up quick. nrmps2 right? like metint said, as long as the curve only goes in one direction. ive done plenty of sunroom with the domed top windows with no problems. even in direct sun.

[blade]

I've done plenty too...a flat curve will lay down fine. you might have a finger pop up here and there but just keep carding it and it'll lay down.

[Guest metint]

can hit 'em with a heat gun (like auto film).  It has a PS adhesive

Thanks

[*]380613

No heat gun Hair dryer only to speed moisture drying under any finger.

if its llumar frost you shouldnt have to heat it.  that adhesive is super strong and tacks up quick. nrmps2 right?   

[*]380648

That's because it has the same adhesive as safety film.

  keep carding it and it'll lay down. 

[*]380679

[hoosierwindowtek]

Personally, I'd be quick to tell the persons involved that there's no warranty since it's plexi. Make sure there's no sun exposure, too.

If it were glass, no problem. with plexi...

[blade]

I wouldn't be doing it with it being plexi

[Guest vclimber]

...