o4 Trailblazer

[Guest Braud Spectrum]

What were they thinking? Just got rid of the Fords stupid hump on the door panel at the bottom of the D & P and now Chevrolet decides it's a good idea?

[Mr paladin]

I didn't notice I just did a 04 traiblazer yesterday

[Guest thetintshop]

I don't think you meant a trailblazer.

[Guest thetintshop]

maybe it was a tracker. but trackers have always had this. even back when they were Geos.

[Guest Braud Spectrum]

Yes it's a trailblazer. Not the F250 hump though. The smaller F150 with the hump on the inside. The hump is only on the door panel. Straight on the outside. So you have to sneak it up over the hump without making a mess.

[Mdog]

BS you talking about the panel up front towards the side view mirror how its raised on the inside making it hard to squeege? I know what your talking about if thats what you mean

[Guest Braud Spectrum]

Yes. That's it. Not only have to lurch up over it ,then it's a bugger to reach down in there and get it below that seal and squeegee. I cut it on the money the second time back in that corner so it barely goes below the seal.

Maybe Trail Blazers always been like that and I just been doing Suburbans and Tahoe's

[Mdog]

I had to use a conqueror to get down in there. pretty door panel.

[Guest Braud Spectrum]

Yep. That's what I used. Passengers side always goes smoother on those kind. Maybe because I can use my right hand to fish and poke more comfortably.

[tinterluigi]

Braud Spectrum, wait till you do a new 04 Ford Freestar it makes the trailblazer look easy . Best to remove the panel.