Jump to content

2012 Wrx

Porsche951

By Porsche951
in Subaru

Recommended Posts

Porsche951

Porsche951

Posted
Posted

Did the hatchback today...relatively easy car, shrinks easily. They now have door frames though :( Side seals on the front roll ups suck, they're really tight but the back were ok. Front roll ups need shrunk. figured id add this since there was no info on this year. Happy tinting!

Link to comment
Share on other sites
Devil with bad attitude

Devil with bad attitude

Posted
Posted

Try trim removal....extremely simple with no heat shrinking needed.

Cover plate comes off the mirror, one screw in behind the door lever latch, one holding the grab handle and then that allows the panel to be released with 2 more screws underneath.

Easy as pie and no water fingers then, no carding, no panel levering.

At the most in time...about I minute as against forever with trim on..

Devil

Link to comment
Share on other sites
Sy@IMAGE

Sy@IMAGE

Posted
Posted

Try trim removal....extremely simple with no heat shrinking needed.

Cover plate comes off the mirror, one screw in behind the door lever latch, one holding the grab handle and then that allows the panel to be released with 2 more screws underneath.

Easy as pie and no water fingers then, no carding, no panel levering.

At the most in time...about I minute as against forever with trim on..

Devil

X2 I always pull and remove trim to make life easier..

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Go to topic listing
  •   Sponsored by
    auto-precut.com

    signwarehouse

    martinmetalwork.com

    tinttek

    filmvinyldesigns

    The Tint Tutor

    ride wrap

    Lexen

    Tint My Ride

    tintwiz

  • Activity Stream

    1. 0

      Flat Glass Installer NEEDED

      Full time Flat Glass installer needed in Lady Lake FL. 3M film, residential and commercial. Mostly solar but some security. This shop has been under the same ownership and in the same location for 34 years. We are the oldest 3M dealer in the tri-county area. Chris Gehman Owner Underglass Auto Tech Inc 334 S. Highway 27/441 Lady Lake, FL 32159 352-753-5267 352-753-8886 fax chrisunderglass@comcast.net
      Underglass in Classifieds • Employment • Marketplace
    2. 0

      Now hiring experienced window tinter

      Car Tunes Brandon is hiring to its growing team for full time position window tinter 8-6 Tues thru Saturday. Call Shannan or Jason with Car Tunes 813-661-4052 112 N. Parsons Ave Brandon,Fl 33510
      CARTUNESONLINE in Window Tinting - General Discussion
    3. 0

      Any XPEL Dealers?

      Are there any XPEL dealers lurking that can answer a question? You can DM me if you prefer.
      DynamicATL in Window Tinting - General Discussion
    4. 13

      Where can I order Window film online?

      You can try Alibaba，and get some samples first.As I know,1 roll is about $100. Whats app:+86 18028875794; email: glassfilm@kashibang.com
      Icey in Window Tinting - General Discussion
    5. 1

      TintX Puremax and Koolmax

      I’ve tried both pure max carbon and koolmax ceramic. So from what I’ve experienced the pure max is honestly very easy to work with and just feels right as the beginner I am. I’ve easily shrunken rear and front windshields as a beginner with the pure max so I know someonewith experience can easily work with it. However I’m not sure if just me but the koolmax ceramic has just been a headache thing to shrink on rear windows only. Heard the adhesive isn’t as good either especially by dot matrix’s which I encountered on a 2000 mustang. But yea I recommend the pure max line although I switched over to geoshield .
      Offwhitetintz in Window Tinting - General Discussion
    6. 7

      Question about VLT variance

      Pulling information from some website.... what you posted is only part of the whole thing.
      Ryker in Tint Laws
    7. 4,171

      What did you tint today?

      LLUMAR AIR80 +xpel xr black 05
      exhume in Window Tinting - General Discussion
    8. 4,171

      What did you tint today?

      Li Auto L7 llumar air80+IRX15
      exhume in Window Tinting - General Discussion
    9. 7

      Cracked glass

      The above post is a bit controversial and naive in nature. May I suggest improving technical knowledge by using a film-to-glass chart, IWFA's study on window film use on dual pane glazing systems, and glass itself. Air/gas used in dual and triple pane glazing systems has zero impact on what gets installed. Absorption rate of film and glass edge quality impact the aforementioned glazing systems most. The film used in the OP has absolutely no reason to be installed to the exterior surface. Neither do the vast majority of film products that carry an absorption rate less than 50%. Start searching for good quality information to better serve you and your clients. And finally, installing on the exterior maybe has a life expectancy of 5-7 years before seeing degradation. Properly installing a product deigned for the interior (on the inside) increases life expectancy up 20-25 years, depending on the quality of the film.
      Tintguy1980 in Window Tinting - General Discussion
    10. 7

      Question about VLT variance

      I just did a minor search on google and found this about the tinting laws of Illinois State. Windshield: Non-reflective tint is allowed on the top 6 inches of the windshield. Front Side windows: Must allow more than 35% of light in. Back Side windows: Must allow more than 35% of light in. Rear Window: Must allow more than 35% of light in. Please keep in mind that it is only for Sedans, if you have SUV then the law is different.
      eddiesagers in Tint Laws
×
×
  • Create New...