E_Loc

35 windshield 35 front port 20 rear port... carbon stable film

I did this camaro 05% came out very nice

Ford focus in 15% Global QDP.

Ford focus in 15% Global QDP.

This is my work

SolarFx Xtreme2 20% film.
2015 Fusion SE.
I enjoyed using this film. Shrinks good. Better then other cermic film I use. Peel liner came off pretty easy. It crushed really well for the few spots i needed to. It didnt really feel extra thick like my other ceramic, which makes me more comfortable installing.  Overall my top ceramic film ive used so far.
 

SolarFx Xtreme2 20% film.
2015 Fusion SE.
I enjoyed using this film. Shrinks good. Better then other cermic film I use. Peel liner came off pretty easy. It crushed really well for the few spots i needed to. It didnt really feel extra thick like my other ceramic, which makes me more comfortable installing.  Overall my top ceramic film ive used so far.
 

Ok, I've done a few of these now and have to say on the whole they are pretty easy. On the hatch I don't bother to disassemble to pull the spoiler I just tack with a horizontal line instead of an H-pattern and bump the film down so I can shrink the top first, then bump up to shrink the bottom. Granted that's using a plotter cut pattern, if you're hand cutting you'll need to remove the spoiler. The doors are cake other than the 1/4 windows which are worse up front than the rear. Remove the 7mm screw behind the handle then pull the top of the panel straight back and the sweep comes right out. On the 1/4s I recommend cutting your pattern exact, the seals are basically bonded to the glass on two sides, if you're using a plotter be prepared to trim your film. Access on the front 1/4 sucks due to the upper trim on the door, hasn't been enough of an issue for me to look into R&I-ing it though. @no ma'am here's the detailed shots you asked for.

This is the 2nd RS model we did with 3M Crystalline.  Crystalline 40 on side and back glass and Crystalline 70 on windshield.  Rear top spoiler must be remove for shrinking the back glass for a easy install. Front windshield on this vehicle is big for such a small car.....Not a easy windshield to heat shrink in Crystalline.
 
There are 7 screw to unscrew to remove rear top spoiler.  The plastic cover will pop off to reveal the 7 screws.  All the blue tape mark all the screw that need to be remove.  The spoiler will pop off with a little muscle on each end.  
 
The front door sweep is super easy to remove.  Remove the door speaker by just popping it off.  Remove cover be hide door handle to reveal screw and unscrew. Get a hook tool and hook out sweep.  Sweep or door panel have to be remove on this vehicle to do a clean install.....TRUST ME!!! 
 
The Back door sweep is the same....

15 challenger scatpack in solarfx

15 challenger scatpack in solarfx

Bringing back a good thread. Last post was January     
 
 



 
 
QDP 20%