2011 f350

[TintDude]

Last quick question, in my case do you guys shrink the fingers on outside or inside?

What do you think would work better?

[Guest filmslayer]

and before answering please consider what a 1000* can do to an interior ....

[Guest milly]

Hmm....Outside lol *feels stupid*

Everytime i tried to shrink them yesterday they would always pop right back up after like 2 seconds,.....

edit: it could have been because i was pushing them down with my squeegee instead of a hard card.

[mikebrook_07]

Every once in a while u gotta get the heat gun on the inside. If u pull panels most of the time u dont have to shrink

[Guest milly]

Every once in a while u gotta get the heat gun on the inside. If u pull panels most of the time u dont have to shrink

Okay well I went for another go at it. I did exactly what you guys said. Cut the bottom first, then sides then roll window down a little and cut top. There were still 3-4 fingers but this time I used a hardcard wrapped in a paper towel to push them while heat shrinking. Worked 100% better than squeegee!

So, I got all of the fingers down, except for one at the top right where I kinda creased it. Other than that one crease and a small light gap at very bottom (i was having a hard time cutting along the rubber seal on outside...) It looks OK. I might can post a couple pictures in a few minutes!

[Guest filmslayer]

[Guest Malcolm E Boo]

[mikebrook_07]

Squeege from the center out to the sides

[Guest Malcolm E Boo]

Squeege from the center out to the sides

Always