cutting bottom lines on doors less fingers??

[quality tintz]

Do you tinters get less fingers when you cut your bottom instead of leaving factory Tint edge??

[Ryker]

No

[Stewy]

Nope. Its the same for me.

[blackoutauto]

I don't think it makes a difference

[quality tintz]

Ok was just wondering cause sometimes fingers keep coming back ....and not on every window..

[quality tintz]

Maybe to much slip solution??

[Pyramids]

as long as the edge is clean_ nope.

[DOOTINT]

If one of the factory edge is beat up from the box being stood on the end by the shipper?,,some boxes say do not stand on end

I will cut the bottom edge for sure

Any crease/bad cut or crap under the film at the bottom edge from a not so clean of tuck will cause a finger and a wet lower seal will add water to the edge

Some lower seals have a arc(not strait)that will pinch or bind the film and can cause fingers

[Tintguy1980]

If one of the factory edge is beat up from the box being stood on the end by the shipper?,,some boxes say do not stand on end

I will cut the bottom edge for sure

Any crease/bad cut or crap under the film at the bottom edge from a not so clean of tuck will cause a finger and a wet lower seal will add water to the edge

Some lower seals have a arc(not strait)that will pinch or bind the film and can cause fingers

 

[quality tintz]

Good info thanks