Jump to content

Audi S8- How to?

Guest thillwtm

By Guest thillwtm
in Audi

Recommended Posts

Guest thillwtm

Guest thillwtm

Posted
Posted

A customer brought in a 2007 Audi S8 today and we had trouble with the rear window. Has anyone tinted this car before? If so are there any suggestions on making the process easier? The problem was encountered when we saw the brake light in the rear window touches the glass and therefore we couldn't get a tool in between.

Link to comment
Share on other sites
Guest Sprinter

Guest Sprinter

Posted
Posted

just a segestion tell them a really high price like lorenzo on his vette and let them walk out the door, why put your self through the pain to tint that thing you can tint 2 normal cars in that time and not put up a sweat.

Link to comment
Share on other sites
lorenzotint

lorenzotint

Posted
Posted
just a segestion tell them a really high price like lorenzo on his vette and let them walk out the door, why put your self through the pain to tint that thing you can tint 2 normal cars in that time and not put up a sweat.

Vette x 2 = S8 is a bargin for a Monday. Custom tint all the way, do the job the right way and gut the beast. Trunk monkeys are a must. :tantrum

Link to comment
Share on other sites
Shades of Gray

Shades of Gray

Posted
Posted
A customer brought in a 2007 Audi S8 today and we had trouble with the rear window. Has anyone tinted this car before? If so are there any suggestions on making the process easier? The problem was encountered when we saw the brake light in the rear window touches the glass and therefore we couldn't get a tool in between.

the audi A8...fun fun fun. The headrests are supposed to come out. You need to pull on them pretty firmly. As for the tight bottom back window. I use 1 or 2 twelve inch white with black rubber edge squeegees to get the lower section.

Link to comment
Share on other sites
the art of tint

the art of tint

Posted
Posted

I do them all the time, got them down to a science now! Pop out the headrest, get a bulldozer and a 12" white and black cut at an angle, and your done!! Or if your lucky and get to tint the Audi W12, the back seats recline so much you dont need to pull the headrests. By the way the W12 is like 2 V6 motors under the hood! Sweet cars.

Link to comment
Share on other sites
Devil with bad attitude

Devil with bad attitude

Posted
Posted
A customer brought in a 2007 Audi S8 today and we had trouble with the rear window. Has anyone tinted this car before? If so are there any suggestions on making the process easier? The problem was encountered when we saw the brake light in the rear window touches the glass and therefore we couldn't get a tool in between.

As we say downunder...."well cut round the bastard."

Devil

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Go to topic listing
  •   Sponsored by
    tintwiz

    auto-precut.com

    signwarehouse

    martinmetalwork.com

    tinttek

    filmvinyldesigns

    ride wrap

    Conco

    Lexen

  • Activity Stream

    1. 3

      Automotive Tint Comparison

      1) Why avoid Suntek? I thought they resolved that issued with the easy scratching and that they are one of the market leaders in Australia? Also, it seems most of the well established Tint businesses use Suntek 2) I've heard mixed things about Rayno, with some installers raving about it and others disparaging it. Makes it difficult for the consumer to know the truth, given vested interests exist. 3) Is Ultragard a Australian exclusive product? The IP seems to be owned by GTS FILMS PTY LTD. How's the quality as it seems to have limited installers. 4) Is the MEP Films CNP that apparently are Manufactured by LLumar of the same quality as the LLumar tints (such as Llumar Formula One Stratos; Llumar Formula One Pinnacle; Llumar CTX)? 5)
      MVOZ in Window Tinting - General Discussion
    2. 1

      Cracked glass

      The crack indicates thermal stress, however, the edge of the glass may have an imperfection (bur or clam shell chip). The crack does run 90 degrees out from the edge and curves as it follows any weaknesses in the pane itself. I have attached a pictured of what tempered glass looks like when it breaks and alongside it what a plate (or float) and heat-strengthened glass looks like when it breaks. The outer panel my be tempered should indicate so by a stamp etched on the glass surface in one corner. It should indicate tempered. Plate glass has no indicators, however, heat-strengthened glass will crack in the same manner as plate glass. I'm an unsure whether heat-strengthened glass requires a stamp. Tempered glass is 4 times stronger than plate and heat-strengthened is 2 times stronger than plate. 1 in 24 is indicative of edge imperfection. I could not find the solar absorption rate of DN 50, but if it is similar to competitive films, there should be no issue with that installation setting (including a straight line shadow). This, too, points back to edge imperfection as the cause. And finally, I spy drapes in a close position, correct? If so, it would be helpful to crack open during sun exposure; this to assist in allowing trapped heat between the glass and drapes to dissipate.
      Tintguy1980 in Window Tinting - General Discussion
    3. 1

      Cracked glass

      Hello. I recently installed Johnson Daylight Natural DN 50 on a couple of windows. Solar energy rejection is 39%. The windows are double pane and the glass is supposed to be tempered 4mm + tempered 6mm. The roof overhang shades the top 1/3 - 1/2 of the windows. However, a few days after installation I noticed that one of the glass has cracked, presumably due to thermal stress. Should I remove the film from the rest of the windows? I installed the film on 24 of these windows (6 tiny houses) so now 1 out of 24 is broken. Or is it more likely that I just got unlucky and the glass had a defect? Is shading from the roof overhang such a big factor? The glass cracked. Is it really tempered? I thought tempered glass would shatter, but not crack. Thanks!
      Geyser in Window Tinting - General Discussion
    4. 6

      Residential Window Tint - Suntek SYDS vs. Solar Gard Slate vs. Madico Optivision

      Did you get this taken care of? What were the results and are you pleased?
      LeadfootCJ7 in Window Tinting - General Discussion
    5. 1

      Residential Film without blue hue?

      Take a look at 3M's Nightvision or LLumar's Dual Reflective series, they both have a warm tone to them.
      Tintguy1980 in Window Tinting - General Discussion
    6. 3

      Automotive Tint Comparison

      Steer clear of Black Armour, Suntek, ASWF. The others are good choices if you are in Australia. Check out the reviews of the installer too. It’s not just the materials that have to be proper. Never go for the cheapest!!!
      jj in Window Tinting - General Discussion
    7. 1

      Residential Film without blue hue?

      Hey guys I am in the process of having window film installed in my home but have a question about which brand I should go with. Hoping yall can help me out. I have a room that faces a busy street and as a result my blinds pretty much always stay closed. I love having natural daylight but not so much people being able to see what i'm doing in my room/all my expensive equipment. I used to work in the window film industry as a helper/installer/salesman when I was in highschool and we did a lot residential/commercial work. The specific brand of film we used always left a certain blue and cool appearance. Is there any brand of residential film that does not have this effect? I mainly just cannot stand having blue light amplified and am looking for a film that has a neutral shade to it or even a warm/yellow hue. I have single pane windows and I do not necessarily care about heat rejection but if I have to pay more for a ceramic film rather than a dual reflective or a standard film I am willing to if that helps solve the issue. Again, any help is really appreciated with this there are so many new window film brands out there and it really is cool to see how far the industry has come.
      dennis_fl in Window Tinting - General Discussion
    8. 8

      South facing window tint

      Thanks for the vote of confidence Tintguy. Recoil, we will take good care of you.
      jnf in Window Tinting - General Discussion
    9. 8

      South facing window tint

      Thank you gents, I will reach out. Appreciate you both!
      Recoil in Window Tinting - General Discussion
    10. 3

      Automotive Tint Comparison

      LLumar, 3M and Solargard have in the industry as far back as the genesis of window film mid-1960's). Solargard is the younger of the three and all others came to play in the last 20 or so years. I've had all three on my vehicles over the years and my current is 3M Crystalline on my Jeep since 2015. It still has stable color, scratch coat is holding strong and impeccable adhesive clarity. Never been garaged. My choice toady would be 3M or LLumar.
      Tintguy1980 in Window Tinting - General Discussion
×
×
  • Create New...