97 silverado

July 21, 2003

how easy never done 1 so dunno wot they are like any advice or things I should look out for

TintDude · July 22, 2003

http://www.commercialvehiclesales.com/myim...73_97_C3500.jpg

the popouts are kind of a b***h

July 22, 2003

B/W and doors a very simple. With the 1/4s.. on the latch push out the pin then remove the 2 screws and there ya go. Let em dry for about an hour and put em back in. :thumb

July 22, 2003

make sure you use a pozidriv screwdriver or you'll strip the heads of the screws.

July 22, 2003

Hell ya. Good point TTS. I forgot about that. They are the worst, softest screws ever. Then GM goes and puts that damn lok tite on em. Idiots!

Mdog · July 22, 2003

atl east on the later year modles of those trucks they quit useing half a bottle of locktite on those bastards

July 22, 2003

That is so true. I would have to heat the fark out of the buttons to loosen that shiot up!!

wndotint · July 22, 2003

I believe it's the '97 ones that have the worst lock-tite. Any other year seems a bit easier.

July 22, 2003

you guys ever drilled them out? they cost like $7 for the little button and the screw. I used to keep several on hand. cause there was always one coming in that wasn't going to break loose no matter what. farkin chevrolet, atleast they got the new ones done right, for us anyway. too bad they leak air like a mother.