I hate the new Camry 1/4 Windows

[FBO]

Its so dame tight in the back area of the glass, do you guys cut that seal all the way to the back? Thanks.

[FBO]

I take them out.

Sorry to ask this, but how do you take them out?

[The ///Man]

You would have to remove the panel and unbolt the post between the glass and vent. Then it will come out

[FBO]

Thank you, ill give that a try next time i do a camry. This was my second car At times it was getting frustrating, but i am getting better Thanks to all you guys.

[msheurs]

first thing we do on these is stick a bone in the back corner of each quarter window. by the time we get to it its widened up and should slide right in.

[Guest Tint-Factory Car Shine II]

first thing we do on these is stick a bone in the back corner of each quarter window. by the time we get to it its widened up and should slide right in.

That would be a lot easier than removing the panel since you can pry the top back and pull the strip out on these.

[FBO]

first thing we do on these is stick a bone in the back corner of each quarter window. by the time we get to it its widened up and should slide right in.

That would be a lot easier than removing the panel since you can pry the top back and pull the strip out on these.

Would that cause any wind noise, or water leaking?

[VIP tint + glass]

i pull the panel and just loosen up the lower rubber. pry it back, spray some water, get your tint pretty far back, then puch it the rest of the way back there with your corner card.

imma try that bone tool trick next one i get though

[yz101]

Pulling a panel and removing a glass in LESS than a minute... it takes me at least 2 minutes just to find my tools that my co-workers didn't put back!

[The ///Man]

I spit on it and slide it in nice and easy