Jump to content

commercial glass


Recommended Posts

I have this project coming up, these are large nasty 1/4" single panes (largest is 89x107 and 92x90). It's in an older part of town with old aluminum frames, these are not tempered and I can't imagine them being 1/4 plate glass due to safety! I am doing exterior black out on half and some interior syds35%. How can I tell if their laminated or not??

IMG_05281.jpg

IMG_05291.jpg

Link to comment
Share on other sites

  • Replies 36
  • Created
  • Last Reply

being an old building I would lay odds that it is going to be just 1/4 plate glass. Unless it was replaced in the last 10 years or so and then it would likely be tempered. I would not even think it would be laminated with those sizes.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


  •   Sponsored by
    autocut-tech

    tinttek

    filmvinyldesigns

    ride wrap

    Lexen

    d2iwindowfilm.com

    tintwiz

    signwarehouse

    martinmetalwork.com

  • Activity Stream

    1. 4

      IR or UV Coating on glass.

    2. 4

      IR or UV Coating on glass.

    3. 4

      IR or UV Coating on glass.

    4. 0

      Independent Contractors needed for Security Film Project- Houston

    5. 4

      IR or UV Coating on glass.

    6. 0

      Mutoh Plotter

    7. 4

      Reveal Molding/Belt Moldings

    8. 4

      Reveal Molding/Belt Moldings

×
×
  • Create New...