vinyl roll racks

envious eric · August 13, 2014

what is out there? I would like one to be on a rolling system holding 10 rolls or so. anything in the so cal area, or at least that can be ordered online from the states. Found one, but its UK.

Thanks. I just cant keep stock piling the rolls in my office!

waxworkz · August 13, 2014

Maybe post this in the tools section?? Might get more replies

August 13, 2014

2 4x4 studs a whole saw and 10 1" PVC pipes.

waxworkz · August 14, 2014

PVC?? More like pipe steel! PVC would snap under the weight of a full roll

Mpameno81 · August 14, 2014

I just mounted up a couple 90 degree hooks and used a 6' wood hand rail as a dowel. Just make sure to hit studs, the full rolls are really heavy.

envious eric · August 19, 2014

its for concrete walls if I do go that route.

I dont want to just slap something together, I would like a bullrack type setup. plastgrommet.com for what I am talking about

Thinking a 6' x 8' table with two Aframe stands on one side might be a good option to have ease of use/cutting. Maybe Ill just get the verticle roll rack and then transfer one by one when needed.

decisions decisions....

jason@aerotect · September 4, 2014

Not cheap, but it holds a lot of weight:

(sorry, for some reason image is not pulling through to the thread.)

TintDude · September 4, 2014

Not cheap, but it holds a lot of weight:

http://www.aerotectfilms.com/images/1080_rack

(sorry, for some reason image is not pulling through to the thread.)

Because it has no image extention like "jpg" or"gif" so for security the forum wont allow extentionless files. :thumb

jason@aerotect · October 15, 2014

Thanks!

Not cheap, but it holds a lot of weight:

http://www.aerotectfilms.com/images/1080_rack

(sorry, for some reason image is not pulling through to the thread.)

Because it has no image extention like "jpg" or"gif" so for security the forum wont allow extentionless files.