Lint free clothes or a paint suit??

[quality tintz]

Guys been thinking lately about stuff getting in tint..would gloves and a pantsuit work or armor wear??shady??plastic gloves for skin shedding??

[smookee408@yahoo.com]

😂 put the 🍺 Down. I think you might of had one to many. It's good thinking outside of the box though. Try controlling your environment instead. Like reducing clutter or area where dust can collect. Having clean floors and using a leaf blower will greatly reduce contamination. If you're really worried about lint then try wearing a nylon type jacket or pull-over. 

[quality tintz]

20 minutes ago, smookee408@yahoo.com said:

😂 put the 🍺 Down. I think you might of had one to many. It's good thinking outside of the box though. Try controlling your environment instead. Like reducing clutter or area where dust can collect. Having clean floors and using a leaf blower will greatly reduce contamination. If you're really worried about lint then try wearing a nylon type jacket or pull-over. 

Thanks suit and gloves helps 100 percent with cars why not tint???

Edited September 15, 2017 by quality tintz

[smookee408@yahoo.com]

Maybe you'll have better luck with gloves. I've tried it before and it doesn't feel the same. I just spray my finger tips before touching the film. Even then it's only on the edges where it won't be seen. 

[Stewy]

Spray the floor a lil bit. Always keep your hands wet.  Don't touch anything but the film. Don't let any wind get anywhere near you. Spray the air right before your remove liner. Install the film faster after you remove the liner. 

 

Where is the contamination on your film?

[TQtinting]

I always clean my shop with water hose and scrub brush on regular basis floors, walls, garage door, everything. And if anything the one thing I do outside the box is keep a lint roller handy and that's only to keep dog hair or anything else off of my shirt I always end up with clean results doing this

[quality tintz]

2 hours ago, Stewy said:

Spray the floor a lil bit. Always keep your hands wet.  Don't touch anything but the film. Don't let any wind get anywhere near you. Spray the air right before your remove liner. Install the film faster after you remove the liner. 

 

Where is the contamination on your film?

Mostly on top edge it's getting better stew extra scrubbing with alchohol 

[DOOTINT]

If you had enough alky you wont see the specs or care about them lol

 

After clean/prepping a dirty dusty car maybe wash your hands up good before peeling and installing and wipe the tip edge of glass with a clean towel

Edited September 15, 2017 by DOOTINT

[Jake]

One thing I have noticed with a few of my guys in the past, they would not clean the top of the door frame. When you are working on the door it is being bumped and moving. Dust can fall down from the frame. I always clean all around the frame above the window to help with this. I have thought about a paint suit when installing PPF. Wouldn't hurt.

[WearTheFoxHat]

When our guys tint cars they do it NAKED shaved bald EVERYWHERE and shower between vehicles.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

KIDDING we don't do cars