isaiahdrums

Doors 
- These were pretty hard. I did NOT take off the panels or remove sweeps. The hard part was getting the film in the sides cleanly, so tape over the felt or do whatever you do to have "felt" control.
 
BG
- Standard and easy. I put the film under the third brake light at the top of the window with no issues.
 
Windshield
- Standard. As always be careful with water, just because of all the electronics.
 
Overall Difficulty:
4/5 Because of doors

Windows
- Easily pull out sweeps, just take out the screw on outside of panel towards you.
- no need to snap/heat shrink whatsoever! Super easy
 
BG
- piece of cake! 
- i didnt pull the rear deck, i just took my olfa and cut the rubber pieces that stuck to the bg. 
It was still a little rough to get behind there with a bulldozer, but came out clean!
 
Overall Difficulty:
1/5! one of the easiest cars i've done.

I thought about doing that too, but now I am seeing a common issue with their rear window breaking due to stress.  This can just happen for no reason and a bunch of people has had to warranty it.  The rear glass is two thin layers sandwiched together.  Every time I think stop being a b!tch and just do them, I find out more design issues.  Hell no, find another shop.

WINDOWS
   - super easy, panel pulls back 
   - be careful of front windows. carefully slide the tint behind the door on the top left corner.
 
BG
   - Super easy, i heat shrank after i installed.
 
Difficulty
1 out of 5

2011 X6 
 
Windows
- I didnt take sweeps out
- if the back has the privacy glass, putting 30 on top will make it literally 15%
- pretty easy, make sure you snap them. Fingers still kinda pop up here and there.
 
BG
- easy, but you'll need a step stool if you're short like me hahah.
 
DIFFICULTY
1.5/5

Easy peasy, same as the '16 and '17s. Remove screw behind handle, pop tops, pull seal. Rinse and repeat.

2010 
Side Windows
 Super easy. I didn't bother taking the sweeps out and no need to snap them!  
Back Glass
 A tad difficult on the corners.  
Difficulty out of 5 = 2/5

2018 Avalon
 
Sweeps
- front doors are attached to sweeps, but come out easily
- back doors arent attached but have clips!
 
Windows
-Super easy to tint
 
Back Glass
- super easy!
 
 

Just did one today and to add to it, I pulled the panels which is three screws with one hidden under the window switch. Just pry underneath and it pops right up. These are the seals that need removing to make reinstall of the panel easier. Also the rear shade button is right below the ac controls. 

2015
Sweeps
- You'll have to take the panels off. I didnt even bother with doing that.
 
Windows
- Their pretty fair. Just squeegee out the top pretty good then roll up the window and do the rest.
 
Back Glass
- super easy!
 
 
DIFFICULTY: 3/5

2015
 
Windows
- sweeps pull out easy and fairly easy to put back in.
- the windows are super easy, no need to snap
 
Back Glass
- super easy!
 
Difficulty: 1/5
 

18 tundra
 
Sweeps
-Theyre attached to the door panel. i pulled them back on the fronts but not the back 
 
Windows
-Super easy including back window. didnt snap or heat shrink anything.
 
Difficulty: 1/5

2018 Avalon
 
Sweeps
- front doors are attached to sweeps, but come out easily
- back doors arent attached but have clips!
 
Windows
-Super easy to tint
 
Back Glass
- super easy!
 
 

2018 Avalon
 
Sweeps
- front doors are attached to sweeps, but come out easily
- back doors arent attached but have clips!
 
Windows
-Super easy to tint
 
Back Glass
- super easy!
 
 

Real light mist?

You can also pull the molding around the window out easily to allow for a simple install. No need to try and push it behind the seals that way.

This is the easiest CRV to date!!!
 
Easy gasket removal....just pull back top door panels and remove gasket.
 
Rear BG shrinks with ease....NO MORE bottom curve like previous CRVs!!!!!!
 

 
 
 
 

 

It was only posted 4 years ago give it time
 

Use a spray bottle on the back window, no problem.

It is an easy one to top load but if you want to pull the gaskets to bottom load remove the screwbehind the handle, pop the top back(if it's super tight you can release the clips one at a time from the outside using a bone tool and a pick) I use a couple yellow turbos as wedges to hold the top of the panel back and then pull the seal.

Just did front windows and windshield. pretty easy car. I couldnt get the gaskets out.
 
No need to heat shrink front windows. 
Windshield was really easy as well! 

Limited quantity I hear. Anyone do one yet? They're incredibly easy, and a hatchback. I had no pattern, so had to give it a hand job.

2017
 
Gaskets easily removable. big windows, no snapping needed. of course heat shrink back window, HIGHLY RECOMMEND dry shrinking and being careful of the bottom corners.  the back window is a sneaky lil bastard lol. Harder than it looks.
 
SUPER EASY!!!!
 
 

- Top of door panels come off with the felt gaskets! Easy. 
Also easy to place right back.
- Tinting: Super easy! No heat shrinking needed. 
 
Level of difficulty
1 out of 5

- Top of door panels come off with the felt gaskets! Easy. 
Also easy to place right back.
- Tinting: Super easy! No heat shrinking needed. 
 
Level of difficulty
1 out of 5