will this dry out..rwar glass line bubble

[tools]

rear glass...will these dry out if not suggestions appreciated...tks

[tools]

re:  line bubble...

 

line bubble is thin..maybe 2-3 cm...about 1.5-2" long..

 

will it dry out ...or any suggestions here?

Edited October 2, 2018 by tools

[no ma'am]

No, but you should be able to card it down towards the defrost start with the first pic and take what you learned to the second 

[tools]

thanks man..after initial install i was carding these out but they kept returning...its been several days so maybe they will card out without resurfacing after having a few days of curing n drying

[tools]

do you think waiting a week is too long to card these bubbles out?

[jh812]

3 minutes ago, tools said:

do you think waiting a week is too long to card these bubbles out?

Maybe so but can't hurt to try.

[Blackwolftinting]

Use a heat gun on them when you see them. Push top to the defrost line, bottom to the defrost line. They’ll usually stay down. If you have any that are a pain and won’t lay, you can put a really small score line running along the defroster line. Then heat, push both ends towards the scored line. I had this on a new 300C the other day. It happens from time to time and is super annoying. 

[quality tintz]

Cut on defroster line like they said push up to cut and top down to cut.....bubble gone if glue on film is good...try some heat or in direct sun if bubbles are stubborn.....

[no ma'am]

I stick to ma story... let it dry and don't trap air (be careful) carding it down, your thumb nail is an excellent touch up tool if the films scratchcoat doesn't suck.

[tools]

so dont try to push it all out thru the sides?

 

if i line it up to the defroster line...i will leave a bubble at the defoster??