Have you ever seen windows this bad?

[callwild]

This is something I really worry about, how do you know a film isn't going to do this in 5 years time?

By using a quality film.

Really there are far more important things to worry about.

[Guest crossy67]

You might think so but I believe a bad job will ruin a reputation. I agree use a good quality film.

[Tintguy1980]

Poor quality adhesive used when produced or poor squeegee technique installing; more so in this example, I would lean toward poor adhesive and mostly along the lines of it only having a heat-rating of 160 degrees F (like LLumar's adhesive in the mid-80's). There are different temp ratings to choose from when buying PS adhesives for film production; today's high quality PS adhesives have a rating to 250, possibly higher (sustained over several hours exposure).

The example pictured above shows what gravity can do to a soft, low heat rated adhesive over time.

[The ///Man]

Seen that on old sungard Steel.

[Tint Eastwood]

Ripple glass is very expensive. That manufacturer should be selling it for flat glass.

No doubt.

[dbdreams]

I must be fortunate because I have been using SunGard for over 18 years & I have never seen SunGard that bad. I do use their HP line though so that couldn't hurt things. I would not want to drive that car like that but whatever film it is at least it's not purple.

[Guest Tinter24]

I had an older limo that came in like this. had to remove and retint, never again!!!!

[TintDude]

Poor squeegee technique? Not sure I understand. Leaving too much slip behind?

[dbdreams]

Poor squeegee technique? Not sure I understand. Leaving too much slip behind?

Yeah I didn't understand that comment either unless he thought it was a recent tint job. Just looks like tint that is way past the end of it life to me

[TintDude]

X2

Sounds like something a rep would say right after saying, "You are the only one having a problem.".