2017 Range Rover.

[pitu]

Anybody tinted these window without remove door panel. 

[no ma'am]

Yep, only problem I had really was slip not acting right so clean the shit out of em.gaskets aren't real tight 

[Super Dave]

Also, run some tape and plastic over the switches and panels. The panels can streak pretty bad depending on your slip. The switches will hold water when you rinse the bottom half, never burned one up, but I did have one act funny for a few hours. Now I make sure to cover them!

[Ryker]

Did one today.  Popped the top and cut the sweep loose.  Easy Peasey

[Super Dave]

Always been a little scared of cutting that, but always wanted to. Once you got it back together, do u think anyone would ever be able to tell the difference?

1 hour ago, Ryker said:

Did one today.  Popped the top and cut the sweep loose.  Easy Peasey

 

[Ryker]

On 3/6/2018 at 9:49 PM, Super Dave said:

Always been a little scared of cutting that, but always wanted to. Once you got it back together, do u think anyone would ever be able to tell the difference?

 

Only person that would know the difference would be a body man taking the door apart.  

[Super Dave]

Thanks, I get them here and there from the lambo dealership. It’s usually a freebie set of front doors for a manager or his family member. I definitely don’t like doing them, but with that seal out, it’ll be a much cleaner/faster install!

[360Tinting]

First time with rover and it’s been a challenge. So cutting the sweep any particular way? And I’m using a precut pattern any suggestions. Any advice would be greatly appreciated thanks 

[Ryker]

Cut the far front and back 90 degree point so that the sweep is "normal".

[360Tinting]

Gotcha, thanks for your time